Catalog My Shed
Tractor / Loader LIVE OEM REFERENCE

McCormick Farmall Cub

1960 McCormick Farmall Cub row-crop/utility tractor (Serial 221399 J, Rockford clutch suffix)

Quick-Glance Shop Specs

Full Matrix ↓
ENGINE OIL SAE 30 / 15W-40 3.0 qt w/ filter
HYDRO / TRANS SAE 80W-90 / 90EP 2.0 qt trans / 1.75 qt final ea
FUEL / COOLANT 87 Octane Gas 7.5 gal / 9.75 qt 50-50
PLUG / GLOW Champion D21 / D16 18mm / Gap 0.025 in
WORK / CUT SPEC PTO 1800 RPM 10-spline 0.812 in counter-clockwise
TIRES / BATTERY Group 19L (6V/12V) Positive ground 6V original
Technician Field Note

The Cub uses a thermosiphon cooling system—there is NO water pump or thermostat. Never overfill the radiator past the baffle plate, and ensure cooling fins and passages are entirely free of lime and debris, or it will overheat rapidly under load.

OEM Preventative Maintenance Schedule

Factory operator manual checkpoints for McCormick Farmall Cub

5 Milestones
10 HR

Daily / Every 10 Hours

  • Check engine crankcase oil level on dipstick
  • Inspect oil bath air cleaner cup and refill with clean engine oil if sediment reaches 1/4 inch
  • Check coolant level in top tank above core tubes
  • Inspect fuel sediment bowl for water and dirt accumulation
50 HR

Every 50 Hours

  • Grease front steering spindles, tie rod ends, and front axle pivot pin
  • Lubricate clutch release bearing / throwout grease fitting (do not over-grease)
  • Check transmission and final drive gear lubricant levels
  • Clean radiator cooling fins of dust, chaff, and dirt
120 HR

Every 120 Hours

  • Drain engine crankcase and replace engine oil
  • Replace cartridge engine oil filter and clean housing canister
  • Service and flush oil bath air cleaner assembly
  • Inspect fan belt tension and adjust generator belt deflection to 1/2 inch
250 HR

Every 250 Hours

  • Remove and clean spark plugs, check electrode gap (0.023 - 0.027 in)
  • Inspect distributor/magneto breaker points (0.020 in gap) and clean internal rotor
  • Lubricate distributor cam wick and generator bearing wells
  • Inspect Touch-Control hydraulic fluid level (IH Hy-Tran) with arms retracted
500 HR

Every 500 Hours / Seasonally

  • Drain and refill transmission and differential case with SAE 90 EP / 80W-90
  • Drain and refill both left and right final drive drop housings
  • Flush cooling system and refill with clean water/anti-freeze mixture
  • Clean fuel tank sediment bowl screen and flush carburetor inlet strainer
Workshop Service Reference

Complete Fluid Capacities, Fastener Torques & Clearances

All reservoir capacities, drain/lug/blade/mount bolt torques, valve lash, pressures, and electrical specs — tap any value to copy.

0 Listed Specs
Need Every Fluid Capacity, Bolt Torque & Clearance for McCormick Farmall Cub?

Compile and save the full OEM Workshop Service Manual table (coolant, axles/trans, lug & blade torques, drain plugs, valve lash, pressures) for this exact sub-model.

Routine Service & Filtration Ledger

Engine-first & decal OEM numbers paired with verified cross-references — tap any code to copy

TIER 1 // PREVENTATIVE
Engine Oil Filter Cartridge

Full-flow internal canister element that filters crankcase engine oil.

Spark Plug

18mm commercial spark plug providing combustion ignition.

Ignition Points & Condenser Set

Breaker point contact set for IH battery ignition distributor or magneto.

Sediment Bowl Gasket & Screen

Seals glass fuel sediment bowl and filters debris exiting fuel tank.

Hydraulics, Brakes, Bearings, Drive & Chassis Components

Category-matched heavy wear & chassis replacement parts across OEM and wholesale counters

TIER 2 // HEAVY WEAR
Clutch Disc (Rockford 6-1/2 in)

Friction disc transmitting engine power to transmission input shaft.

Graphite Throwout Bearing

Graphite thrust ring disengaging the clutch assembly when pedal is pressed.

Fan & Generator Belt

Drives the cooling fan and generator off the front crankshaft pulley.

Rear Final Drive Axle Seal

Prevents gear lube from leaking out of the drop axle housing into the brake drums and wheels.

Official Schematics & Manuals

OEM Exploded Assembly Diagrams

Direct lookup portals for belt routing, linkages, hardware callouts, and serial-break assemblies

Known Failure Modes

Common Issues (3)

01

McCormick Farmall Cub: Engine runs rough, backfires, or dies under load

Root Cause: Clogged main jet in IH 3/4-inch updraft carburetor or sediment bowl mesh plugged

Shop Check: Remove the hex brass main jet plug on the carburetor side bowl and clear the tiny orifice using a soft copper wire and spray cleaner; flush fuel strainer.

02

McCormick Farmall Cub: Clutch squeals when depressed, fails to fully disengage, or chatters

Root Cause: Dry or worn graphite throwout bearing or misadjusted clutch pressure plate fingers

Shop Check: Lube the graphite throwout bearing collar grease zerk with IH high-temp grease and adjust clutch release lever clearance through the inspection handhole.

03

McCormick Farmall Cub: Oil leaking onto right rear wheel rim and tire

Root Cause: Failed axle seal in final drive drop housing or overfilled drop case oil

Shop Check: Jack rear axle, remove rear wheel and final drive pan, replace the outer axle oil seal (OEM 350841R91), and refill oil strictly to check-plug level.

Bench Manual & Seasonal Prep Generator

Step-by-Step Repair, Winterizing & Startup Guides

Tap a seasonal storage/prep checklist, select a failure mode, or type any repair job below.

Seasonal Storage & Pre-Season Prep:
Tap a seasonal storage/prep button, select a common issue, or type a repair job above to load step-by-step instructions and needed parts.
Community Bench Notes

Shared Mechanic Tips for McCormick Farmall Cub

Wrenching shortcuts, hidden grease fittings, left-hand threads, and fitment notes from other techs.

0 Notes
Share a Bench Tip
No mechanic notes posted for the McCormick Farmall Cub yet — share the first bench tip!
Free Shop Fleet Tracker

Own or Wrench on a McCormick Farmall Cub?

Clone this card into your private Shed to log operating hours, track Next-Oil due alerts, and print a weatherproof QR equipment tag.